When you receive the case, the panels will usually have protective plastic or paper covering. Remove all protective coverings before assembling the open frame case.
|Start with the bottom panel - attach the 4 adhesive feet inside the 4 mounting holes as illustrated.|
|Continuing with the bottom panel, insert 4 of the supplied M3 screws through the panel. Then add one of the colour-matched spacers to each screw as shown.|
|Now gently lower the assembled MiSTer Multisystem PCB onto the 4 screws.|
|Next, fasten the 4 standoffs onto the screws. We recommend only hand-tigntening these and then tightening further after final assembly.|
|Lastly, attach the top panel using the last 4 M3 screws. Use a screwdriver to tightening all screws, while being sure not to over-tighten and damage the casing.|